Operation
9
721/30 Quick
Check that the square drive is fitted to the right
side of the torque wrench.
If not, push the square drive out through the upper
side to the right side.
For controlled tightening, switch the ratchet to „R”
or, for uncontrolled loosening of joints, to „L”.
Slide the insert over the square drive until it
locates.
Attaching insert tools — 730/5 to
730/65 Quick
Insert the insert tool into the internal square drive
on the face of the head of the wrench. The spring-
loaded locking pin of the insert tool will be
pressed down by the insertion groove.
Slide the insert tool in until it comes to the
endstop. Ensure the locking pin locates in the
hole.
Check to see that the insert tool is properly
attached.
To tighten counter clockwise, turn the insert tool
through 180° before attaching to the torque
wrench.
