Mounting and installation
20
222203 / 600160300010
2020-06-12·BA00·III·en·06
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Linear Luminaire for Fluorescent Lamps
Series EXLUX 6001
Opening and closing the reflector plate
7.4.2 Electrical connections
Electrical connection
Observe the maximum clamping possibility of the connecting terminals
(see chapter "Technical data").
For optional screw terminals, two conductors per clamping unit can be clamped
(through wiring).
Observe the following when connecting to the main supply:
• Clamping must be carried out precisely!
• Do not clamp any part of the conductor insulation!
• Do not mix up the conductors!
• Observe the technical regulations when connecting the conductor!
• Clamp the conductor firmly.
• Do not remove the terminal cover of optional screw terminals to clamp the conductor!
Observe the following during mounting and dismounting:
• Version without switch: Disconnect the luminaire from the power supply
and secure it against being switched on again.
• Do not use force when opening or closing the enclosure.
Central lock
• Version with switch: The luminaire is positively disconnected from the
power supply by actuating the central lock.
• In open end position and with translucent cover swivelled down,
an anti-pumping device prevents the central lock from being actuated.
15512E00
Opening:
• Open the reflector plate by
pressing down on the
safety latch (1).
• Swivel down the reflector
plate (2).
Closing:
• Flip up the reflector plate
and snap it into place.
1
2
