Error! Main Document Only.Chapter 5. Installing the Display SystemSTACK ST8130 Series Road Car Display Systems
34
Users Guide
Warning lights
Warning lights
The Display Module has two built-in warning lights. The left-hand
(amber) light is the fuel level warning light and the right-hand (red) light
alerts the driver whenever an alarm has been triggered.
As an option, you can install additional external warning lights for gear
shift and alarm warnings. The external warning lights should be
installed in any position that is in the driver’s direct line of vision, as
they need to be visible at all times.
Stack Ltd can supply suitable external warning lights for installation in
the dashboard (ST536/537) as well as shrouded versions that can be
mounted on top of the dashboard (ST533/534).
ð
If you are using your own warning lights, ensure that the
bulb rating does not exceed 2 Watts; otherwise the Display
Module will be damaged. If you need to use lamps greater
than 2W, connect them to relays and use the output sockets
from the Display Module to switch these relays.
Engine Speed (RPM)
Engine Speed (RPM) Measurement
Measurement
The engine speed (RPM) is measured by connecting the engine speed
wire directly to the ignition system. A single wire, with the label ES,
connects the Display System to the ignition system or low-tension side of
the coil.
