STACK
WiFi Recording System
ST542090-002
7
Prevent connection
Use this option to stop any communication to the module remotely via the WiFi.
Connection status log
This option will show a historical log of any connections made to the current WiFi recorder.
The following functions are
NOT
fully supported via a WiFi connection:
•
Data
Monitor…
•
Data Monitor (Raw)…
•
Chat
Terminal…
•
Network
information…
Note: The above functions will respond with information from the WR module ONLY and NOT
from any other modules comprising the system.
Internal Battery management
The module contains an internal battery pack to provide power temporarily once the vehicle
power is removed. This allows the module to be downloaded via the Wifi even with power
removed. The internal power will automatically turn off under the following conditions:
•
Recorded data present then power off after 10 min from Ignition off.
•
No Recorded data present then power off after 5 min from Ignition off.
•
Internal battery below 9.0 volts then power off immediately.
Notes:
a) The module will not power off when the vehicle power is available.
b) Depending on the normal running cycle of the vehicle, it may be necessary to fully recharge
the internal battery by connecting to a 13 to 20v DC supply for more than 15 Hr.
WiFi Network configuration
Configuring the WR module to connect to your WiFi network is covered in the DataPro Manual
Supplement. ST542085.
IMPORTANT
When the WiFi network configuration is completed the WiFi module will need to
have its TAG & PIN code Authorised. This process MUST be performed using the wired CAN
connection and NOT via the WiFi connection.
