SELECTING A LOCATION
The safe should be flat against the wall and floor.
Remove the baseboard if necessary.
The safe must be mounted to the floor. For
optimal safety and security, the safe should be
installed adjacent to a side wall with minimal
space on either side of the safe, in an isolated,
dry and secure area.
CHILDREN SHOULD NOT PLAY WITH
OR AROUND THE SAFE AT ANY TIME.
LOCKING THE SAFE
NOTE ON LOCKING THE SAFE:
Because the
locking mechanism is deactivated for approximately
3 to 6 seconds after the fingerprint is entered, wait a
minimum of 6 seconds from the time the
combination is entered to lock the safe.
CLEARING THE MEMORY
To clear the memory of all recorded fingerprints,
locate the reset button on the inside of the safe and
press this button for about 5 seconds until the green
light flashes 10 times with 10 beeps (if the sound is
turned on). All recorded scans will be erased.
NOTE:
For security you must record a
fingerprint. Failure to do so will compromise
the safety and security of the safe.
To lock the safe, close the door and rotate
the handle counter clockwise until it stops. If
the handle is not turned until it stops, the
locking mechanism will not lock.
40677-2203
3 14
OPENING THE SAFE USING YOUR
FINGERPRINT
To open the safe, press the scanner with a recorded
finger. The blue light will come on with one beep (if
the sound is turned on) and the scan will begin.
If the green light flashes twice with 2 beeps (if the
sound is turned on), the scan has been accepted and
you will have 5 seconds to turn the handle to open
the door.
If the red light flashes once, the scanner did not read
your fingerprint and you must try again. If the red
light flashes 3 times, the scanner read your fingerprint
and did not accept it.
If there are 3 rejected scans, where your
fingerprint was read, and the red light flashes 5
times with 5 beeps (if the sound is turned on),
you will have an automatic lockout for 60
seconds before you can try a scan again. The
safe will beep one time (if the sound is turned
on) and the green light will flash once when the
lockout period is over.
If there is 1 more rejected scan where your
fingerprint was read and the red light flashes 5
times with 5 beeps (if the sound is turned on),
you will have an automatic lockout for 5 minutes
before you can try a scan again. The safe will
beep one time (if the sound is turned on) and
the green light will flash once when the lockout
period is over.
TURNING THE SOUND OFF/ON
To turn the sound off, press the scanner with a
recorded fingerprint for 10 seconds until the green
light flashes twice.
To turn the sound on, press the scanner with a
recorded fingerprint until you hear two beeps and
the green light flashes twice.
Your safe comes with the beep sound turned
on.
