40645-1511
3 12
NOTE: Do not mix old and new batteries. Do not
mix alkaline, standard or rechargeable batteries.
This safe uses 4 - AA batteries. Under normal use,
batteries will last about 1 year.
NOTE: If the batteries are low, the yellow light will
flash when you start to enter your code.
To replace the batteries, open the battery
compartment on the back of the door by pushing the
tab in the direction of the arrow and install all new
batteries.
BATTERY REPLACEMENT
SELECTING A LOCATION
THE SAFE SHOULD ALWAYS BE KEPT
OUT OF THE REACH OF CHILDREN.
The safe is to be mounted in a wall between two
wall studs, and then secured to the wall studs.
For optimal safety and security, the safe should
be installed in an isolated, dry and secure area.
TURNING THE SOUND OFF/ON
To turn the sound off, press the scanner with a
recorded fingerprint for 10 seconds until the green
light flashes twice.
To turn the sound on, press the scanner with a
recorded fingerprint until you hear two beeps and
the green light flashes twice.
Your safe comes with the beep sound turned on.
NOTE: For security you must record a
fingerprint. Failure to do so will compromise
the safety and security of the safe.
CLEARING THE MEMORY
To clear the memory of all recorded fingerprints,
locate the reset button on the inside of the safe
and press this button for about 5 seconds until
the green light flashes 10 times with 10 beeps (if
the sound is turned on). All recorded scans will
be erased.
