LOCKING THE SAFE
TURNING THE KEYPAD SOUND OFF/ON
You can turn off the "Beep" sound of the keypad by
entering the code
6 3 3
.
To turn the "Beep" sound on, enter the code
6 6.
To lock the safe, close the door and rotate the
handle counter clockwise until it stops. If the
handle is not turned until it stops, the locking
mechanism will not lock.
NOTE ON LOCKING THE SAFE: Because
the locking mechanism is deactivated for
approximately 3 to 6 seconds after the
combination is entered, wait a minimum of 6
seconds from the time the combination is entered
to lock the safe.
SECURING THE SAFE
The safe should be flat against the wall and floor.
Remove the baseboard if necessary.
First place the safe in the desired location. When
your safe is open, you will find 2 plastic disks
covering the mounting hole locations in the floor of
the safe. Remove the plastic disks and drill holes
through the insulation using the same diameter drill
as the diameter of the mounting hardware you are
using.
Use these holes to fasten the safe to the floor. Drill
the appropriate diameter and depth of pilot holes
into the floor depending on the type of hardware
being used and the type of floor surface.
Secure the safe and replace the hole covers.
NOTE: The safe must be secured to the floor.
Use the hardware provided or consult your
hardware retailer for fastening hardware for your
particular mounting surface.
NOTE: This safe must be mounted to the floor.
Failure to do so will compromise the safety and
security of the safe.
SELECTING A LOCATION
40427-1311
3 21
The safe must be mounted to the floor. For
optimal safety and security, the safe should be
installed adjacent to a side wall with minimal
space on either side of the safe, in an isolated,
dry and secure area.
CHILDREN SHOULD NOT PLAY
WITH OR AROUND THE SAFE AT
ANY TIME.
