Functions/settings of the settings menu
Function
Menu item Description/possible settings
Receive codes
S01 RXC
None
(CTCSS/DCS)
CTC: 50 CTCSS frequencies from 67,0 to 254,1 Hz
DCSN: 107 codes from 017N to 754N
DCSI: 107 inverse codes from 017i to 754i
Transmit codes
S02 TXC
None
(CTCSS/DCS)
CTC, DCSN, DCSI like under receive codes
AF expander
S03 EXP
ON/OFF, a 2:1 expander is switched on or off during reception.
Compressor
S04 COM
ON/OFF, a 1:2 compressor is switched on or off
during transmission.
Noise blanker/ANL
S05 NB
ON/OFF, Noise blanker and automatic noise limiter
are switched on/off during reception.
RF attenuator
S06 ATT
ON/OFF, a 20 dB attenuator is switched on/off
during reception.
Hi-Cut
S07 HIC
ON/OFF, attenuates high tones thus reducing
the high-frequency noise
Busy lockout
S08 BSY
OFF: Transmission is always possible.
SQ: While squelch is opened, transmission is not possible
(pressing the key intermediately is not possible).
C/D: During CTCSS or DCS operation, transmission is
possible as long as the code squelch is opened.
Roger beep
S09 RB
OFF/1 to 8 (choose among eight different melodies).
DTMF transmission
S10 BOT
OFF/M01 to M16 (choose among one of 16 DTMF
when transmission
memory location: The corresponding DTMF tone sequence
starts
is transmitted at the beginning of each broadcasting).
DTMF transmission
S11 EOT
OFF/M01 to M16 (choose among one of 16 DTMF
when transmission
memory location: The corresponding DTMF tone sequence
ends
is transmitted at the end of each transmission).
DTMF call
S12 CAL
OFF/M01 to M16 (choose among one of 16 DTMF
memory location: The corresponding DTMF tone sequence
is transmitted at the beginning of the next transmission
when pressing the Call key on the microphone.
Transmitting power AM
S13 PAM
High/low (transmitting power in AM 1 W or 4 W)
Transmitting power FM
S14 PFM
High/low (transmitting power in FM 1 W or 4 W)
Input/modification of the settings in the settings menu
Note:
After 10 seconds without user interaction, the radio set automatically exits the menu, all
modifications will be stored!
Press
SET
key (channel switch) for 2 sec.:
S01
flashes, the settings menu is activated.
Select the requested menu item using the channel switch
(refer to menu table: S01 S14).
After having selected the requested parameters,
press
SET
key again: The corresponding parameter flashes.
By turning the channel switch, the settings can be modified.
(For S01 and S02, additional frequencies or codes can be selected:
To do so, press the
SET
key again.)
Confirm by pressing the
SET
key: The selected parameter flashes again.
Store and exit the settings menu by pressing the
PTT
button.
27
