14
Battery Installation
1.
Remove the two 10-32 screws holding the
Control Panel. Tip the Control Panel towards
you to reveal the back side.
2.
Loosen the two 10-32 screws holding the
Battery Clamp until you are able slip a 6 Volt
screw terminal battery (not included) into the
Battery Clamp. Slide it in until it just touches
the wires coming through the Control Panel.
Tighten the two 10-32 screws holding the
Battery Clamp until the battery feels snug.
Attach the wires to the battery terminals.
Take special care to attach the red wire to
the positive (+) and the black wire to the
negative (-) terminals.
Note:
The Back Stop
is removed for clarity.
3.
Test the connections by pressing the
manual switch, the camshaft should begin to
rotate. Continue to press the manual switch
for two seconds then release. The camshaft
should continue until it completes a 180˚
rotation. The camshaft should rotate in a
counter clockwise direction when looking at it
from the Control Panel end. If it rotates the
wrong direction, check the positve and
negative connections on the battery.
Your Stable Grazer Generation II Feeder is now ready to program and use. The clear friction fit timer cover can
be removed by lifting it away from the control panel.
Please refer to the Owner’s Manual or the decal to the left
of the timer for programming instructions.
Remove
Remove
Slide In To Here
Manual Switch
Battery Clamp