Stabila LAR-250, Руководство по эксплуатации

Страница: 8 / 42

4
Commissioning
- Automatic mode with height of tool alert function (
Y LED
)
For safety reasons, the rotation laser always switches itself off all when it is
switched on in this operating mode!
The unit can be switched on by briefly tapping button (3). Automatic leveling
starts immediately. The green LED (5c) lights up and the Y LED flashes.
The splitter pentaprism begins to rotate and the laser beam comes on.
After automatic leveling, you have approximately 30 seconds in which to set the
laser unit in the desired position, e.g. to adjust its height, set it on a tripod, etc.
During this time, minor discrepancies from the horizontal are ironed out.
Then the laser unit switches to monitored Automatic mode and the Y LED goes out.
Operating modes:
Main applications:
Leveling
Set the unit on a firm base or a tripod.
Tip: It is useful to set up the rotation laser centrally to the subsequent
measurement points.
The rotation speed (buttons 19, 20) and the scan function
(button 16) can be set by remote control. Buttons (17) and
(18) are used to move the scanning line and/or the laser
dot to the right or to the left.
Pressing the button (3), switches the rotation laser ON
and it starts to level itself automatically. Once leveling
is complete, the laser begins to rotate. Depending on
the brightness of the ambient light, you can either use
the laser beam, if easily visible, for marking directly
(always ensure that you mark the center of the laser
beam) or the beam can be received via the receiver.
D
C
3
D
3
19
20
16
17
18
Please note that the center of laser dot is marked!