Stabila LAR-250, Руководство по эксплуатации

Страница: 12 / 42

8
Horizontal checking
1.
2.
3.
7.
4.
5.
6.
If the difference between the 4 control points is less than 1/16" at 25ft
(1mm at 5m) distance and 1/8" at 50ft (2 mm at 10m) distance the permissible
tolerance of ± 1/8" over 100ft (± 0.1 mm/m) is being maintained.
Points 1 and 3 on the unit's y-axis and points 2 and 4 on the unit's x-axis now
correspond.
Repeat steps 4 and 5 to obtain Points 3 and 4.
Mark the position of the visible laser dot on the wall (Point 2).
Mark the position of the visible laser dot on the wall - Measurement 1 (Point 1).
Because the diameter of the beam depends on the distance, you must always
only use the center of the dot!
Switch the unit on (button 3) and wait for it to level automatically. The laser dot
is turned in the direction of the wall (button 17, 18). It is also possible to work
with a receiver.
Set up the rotation laser on a smooth, level surface or on a tripod 25 ft or 50 ft /
5m or 10m from a wall with the front facing the wall.
Turn the complete unit 90° without altering the height of the laser (i.e. the tripod
must not be altered). Let the unit level automatically again. Then turn SP2 in the
direction of the wall in the area of measurement point 1.
Please keep as closely as possible to the alignment shown in (H) because this
simplifies any re-adjustment that may be required
The LAR-250 rotation laser has been designed for building site use and leaves our
factory perfectly calibrated. As with any precision instrument, however, its calibra-
tion must be regularly checked. The unit should be checked before starting any
new tasks, particularly when the unit has been exposed to strong vibrations. After
an impact, the unit should be checked throughout its whole self-leveling range.
Checking the calibration
18
H
H1
3
17
18
17
H2
H4
H3