10
Valve Removal
Hazardous pressure. Stop pump and release all pressure from sys-
tem before working on filter, valve, or clamp.
NOTICE: If multi-Port Valve is below pool water level, close suction and dis-
charge valves before disassembly to prevent draining pool.
1. Disconnect piping from pump and pool.
2. Remove clamp.
3. Remove valve from filter top.
4. To reinstall valve, follow instructions, Figures 6 and 7, Page 7. BE SURE to
follow clamp tightening instructions.
Drain Fitting Installation/Removal
NOTICE: If pool is above height of filter, first close valves in pump suction and
return lines to prevent draining pool. If there are no shutoff valves installed, dis-
connect suction and return lines and raise ends above pool water level.
1. Installation: See Figure 13.
2. To Drain Filter:
A. Remove drain cap. Lateral tube should remain in place inside drain
opening to prevent sand from draining out.
B. Open union coupling on backwash port of Multi-Port valve. This will
allow air into filter and allow water to drain from filter tank.
C. Replace cap when tank is empty.
3. Removing Sand From Filter:
A. Remove both drain cap and slotted lateral tube (see Figure 13). Sand and
water will drain from tank.
B. To completely flush filter tank of sand, remove top clamp and multiport
valve and flush the inside of the tank with a hose.
C. Thoroughly clean sand from all parts and from tank drain opening be-
fore reassembling drain fitting.
About 1"
Small
O-Ring
Open end
of lateral
Seat small
O-Ring
Large
O-Ring
End of lateral is
flush with end of
drain fitting
746 0294
Figure 13: Drain Fitting Assembly.
This assembly allows water to drain
without losing the sand out of the fil-
ter tank.
Make sure all surfaces are clean and
free of sand. Don’t cross thread cap;
don’t overtighten cap.
