ST STM32L562E-DK, Руководство пользователя, Страница: 11 / 61

Figure 7 shows the CN8 STDC14 connector pinout.
Figure 7. CN8 STDC14 connector pinout
Table 5 describes the CN8 STDC14/MIPI10 debug connector pinout.
Table 5. STDC14 connector pinout
STM32 pin Board function Pin Pin Board function STM32 pin
- - 1 2 - -
VDD Power 3 4
T.SWDIO: Target SWDIO
using SWD protocol or Target
JTMS (T.JTMS) using JTAG
protocol
PA13
GND Power 5 6
T.SWCLK: Target SWCLK
using SWD protocol or Target
JCLK (T.JCLK) using JTAG
protocol
PA14
GND Power 7 8
T.SWO: Target SWO using
SWD protocol or Target JTDO
(T_JTMS) using JTAG
protocol
PB3
- KEY 9 10
T.JTDI
(1)
: Not used by SWD
protocol, Target JTDI (T.JTDI)
using JTAG protocol, only for
external tools
PA15
(1)
- GNDDetect: Pull-down 11 12
NRST: Target NRST using
SWD protocol or Target JTMS
(T.JTMS) using JTAG protocol NRST
PA10
T.VCP_RX: Target RX used
for VCP (can be a UART
supported bootloader)
13 14
T.VCP_TX: Target TX used
for VCP (can be a UART
supported bootloader)
PA9
1. PA15 is used by default for the UCPD_CC1 feature. To use PA15 for JTDI, add R42 resistor. In this case, the UCPD_CC1
feature cannot be used.
UM2617
Embedded STLINK-V3E
UM2617 - Rev 2
page 11/61