D
R
A
F
T
Hardware layout and configuration
UM1461
18/65
Doc ID 022138 Rev 1
2.18 Camera
module
A camera module is connected to DCMI bus of STM32F407IGH6 and shares the same I/Os
with the motor control connector. SB16 must be kept open for camera module application.
There are two possible modules and omnivision cameras populated on the CN15 connector
of the board:
●
1.3 Megapixel: Module CN01302H1045-C: Camera OV9655
●
2 Megapixel: Module CN020VAH2554-C: Camera OV2640
Note:
1
When the camera demo loaded in Flash is executed, some green pixels may appear in high
contrast zones, depending on the image captured.
2
The camera is not firmly restricted on its connector (CN15). It is possible that during
shipment the camera could be unplugged. In such case you need to plug it into the right
position as shown on the picture below (pin 1 dot on top left corner of the socket).
It is not recommended to remove it in order to avoid false contact later.
Table 13.
Camera module related jumpers
Jumper
Description
JP26
To set power down mode for the camera module, JP26 is fitted.
Default setting: Not Fitted
SB16
Description of SB16 is in
Section 2.9: Motor control
.
All manuals and user guides at all-guides.com