ST STEVAL-PCC009V2, Руководство пользователя

Страница: 7 / 53

UM0935 Section organization of the user manual
Doc ID 17398 Rev 3 7/53
1 Section organization of the user manual
The user must go through Section 2.1 to Section 2.4 of this manual to perform the initial
setup that is required to run the IBU UI tool. After reading these sections, the user can
understand how to install the software and hardware setup.
To choose how to select a communication interface, the user must read Section 2.5 , this
section explains the seven modes (as shown in Table 1 ) that are available in the 10-pin and
30-pin header and how to select which interface mode is best suited to the development of
their application.
After this, the user must decide which communication interface of a 10-pin or 30-pin header
should be used. As shown in
Table 1 below, Section 3 is documented in such a manner that
the user need only refer to the section corresponding to the communication interface to be
used. For instance, if the user wants to use the UART2 interface mode of the 30-pin header,
they need only refer to
Section 3.7 of this document.
Section 4 explains how to use the DFU capability of this tool. This section needs to be
referred to when there it is necessary to update the firmware of the microcontroller of this
tool.
Table 1. Section to be referred to for a particular mode of a 10-pin or 30-pin
interface
Header Interface Refer to section
10-pin header
I
2
C mode 3.1
SPI mode 3.2
UART mode 3.7
30-pin header
I
2
C mode 3.7
SPI mode 3.7
UART1 mode 3.7
UART2 mode 3.7