ST7-EMU3 series emulator
EMC conformity and safety requirements
Appendix A
EMC conformity and safety requirements
Warning:
This product conforms with the 89/336/EEC Directive. It
complies with the ITE EN55022 standard for EMC emissions
and generic 50082-1 (1992 edition) immunity standards.
This product is an FCC Class-A apparatus. In a residential
environment, it may cause radioelectrical disturbances.
Use in life support devices or systems must be expressly
authorized.
STMicroelectronics products are not authorized for use as critical components in life support
devices or systems without the express written approval oF STMicroelectronics. As used
herein:
1.
Life support devices or systems are those which (a) are intended for surgical implant
into the body, or (b) support or sustain life, and whose failure to perform, when properly
used in accordance with instructions for use provided with the product, can be
reasonably expected to result in significant injury to the user.
2.
A critical component is any component of a life support device or system whose failure
to perform can reasonably be expected to cause the failure of the life support device or
system, or to affect its safety or effectiveness.
This product respects the EMC requirements of the European guideline 89/336/ EEC under
the following conditions:
●
Any tester, equipment, or tool used at any production step, or for any manipulation of
semiconductor devices, must have its shield connected to ground.
●
All provided ferrites must be attached as described in the hardware installation
instructions of the relevant user manual(s).
●
The product must be placed on a conductive table top, made of steel or clean
aluminum, grounded through a ground cable. Before every contact with the emulator,
the operator must touch the surface of the grounded worktable just behind the rear
panel of the ST Micro Connect box. All manipulation of finished must be done at such a
grounded worktable.
●
The worktable must be free of all non-antistatic plastic objects.
●
It is recommended that you wear an antistatic wrist or ankle strap, connected to the
antistatic floor covering or to the grounded equipment.
●
If no antistatic wrist or ankle strap is worn, before each manipulation of the powered-on
tool, you must touch the surface of the grounded worktable just behind the rear panel of
the ST Micro Connect box.
●
It is recommended that antistatic gloves or finger coats be worn.
●
It is recommended that nylon clothing be avoided while performing any manipulation of
parts.