PROBLEM
PROBABLE CAUSE
SOLUTION
5.
Grass accumulates
around the shaft
housing and line
holder head.
Too high grass is being cut
close to the ground.
Cut tall grass with a sweeping
motion to avoid build up.
6. The line is not released
when the line holder
head hits the ground.
The line is stuck.
Lubricate with silicone spray.
Not enough line on the
reel or reel empty.
Replace the line (chapter 8.1.3.).
The line is worn and too short.
Pull the line whilst pressing
the release button.
The line is tangled on the reel
or broken inside the reel.
Remove the line from the reel and
rewind it (chapter 8.1.3).
7.
The cutting means
comes into contact
with a foreign body.
-
Stop the machine, disconnect it
from the battery backpack and:
•
inspect for damage;
•
check for and tighten any loose parts;
•
have any damaged parts replaced
or repaired with parts having
equivalent specifications.
8. Excessive noise and/or
vibration is experienced
whilst working.
Loose or damaged parts.
Stop the machine, disconnect it
from the battery backpack and:
•
inspect for damage;
•
check for and tighten any loose parts;
•
have any damaged parts replaced
or repaired with parts having
equivalent specifications.
9. The machine emits
smoke during operation.
Machine damaged.
Do not use the machine. Immediately
stop the machine, disconnect it
from the battery backpack and
contact an Authorised Service Centre.
10.
Battery power
reserve is low.
Severe working conditions
requiring greater
current absorption.
Optimise operations (par. 7.2.1).
Battery is insufficient for
operating requirements.
Use a second battery or an
extended battery (par. 15.1).
Decrease in battery capacity.
Purchase a new battery.
11.
The battery charger is
not charging the battery.
Battery is not correctly inserted
in the battery charger.
Check it is correctly inserted (par. 7.2.2).
Unsuitable environmental conditions.
Recharge the battery in places with
suitable temperatures (see battery/
battery charger instruction manual).
Dirty contacts.
Clean the contacts.
The battery charger is not energised.
Check it is plugged in and the
power socket is energised.
Faulty battery charger.
Replace with an original spare part.
If the problem persists, refer to the
battery/battery charger manual.
If problems persist after having performed the operations described above, contact your dealer.
Содержание BC 900 D Li 48
