SST Automation GT200-HT-RS, Руководство пользователя

Страница: 38 / 52

WWW.SSTCOMM.COM 38
4.2.10 Serial Debug
Through this function could send any request message to Hart instruments and record the response
information. Steps are as follows:
1. Set the DIP switch’s debug bit to ON state and the configuration bit to OFF state, restart the gateway.
Now GT200-HT-RS is in the debug mode.
2. Use a serial port line to connect the GT200-HT-RS’s RS-232 port and computer RS-232 serial port or
use USB way to connect it, open the software “SST-HT-CFG”, Click “Config—Serial Connection”,
Select the correct serial port
3. Click “Tool—Serial Debugging Assistant” or click on the icon , Interface is as follows:
In this interface, click “Auto-send” or “Send” will combine data head, data, and check code into one frame
and send out it. The data that the gateway received from HART fieldbus will be shown in the blank place below.