39
• Jumper Setup as master or Slave, Following the
`
Direction of Surface of Hard Disk.
• Jumper Located at Hard Disk Data Cable or
1
Rear Side of Hard Disk.
• If one hard disk Installation, setup as Master
If two hard disk Installation, second one setup as slave.
① Jumper Setup as Master or Slave
※ Example of Samsung HDD Jumper Setup
• Refer to general pin setting in jumper pin setting on HDD surface.
• When one HDD install, setup pin as master and connect pin
1
at the left end of jumper.
• When two HDD Install or additional Install, first one setup as
1
master and the other is for slave. slave setup has no pin.
• When more than two HDD install, setup as master or slave
1
to connect one IDE cable at the same method of above.
!!Please use hard disk which possible to supply higher than
UDMA66
.!!
‼ When hard disk add or exchange,
Must system off
properly (System off by power button)
. If not, it
’
s a
cause of fatal hard disk error.‼
② IDE Cable Connection to Main Board
• Confirm the IDE cable inside of product
• Among the three connector, Indicated blue color
1
connector must be connected with main board. other
1
connectors connected with HDD
* HDD Installation
SUPPLEMENT
