SS-15 BRI (ISDN 2 GSM) USER MANUAL
DOC. NO: SS-15-14 (REV. 01)
Page 16 of 26
For details see Chapter 4.2, about modes of connecting the SS-15 ISDN 2
GSM unit.
4.10
MOUNTING THE SS-15 BRI (ISDN 2 GSM) EQUIPMENT
When selecting the location for mounting the SS-15 BRI refer to the
recommendations in par. 6.1.
The SS-15 BRI (ISDN 2 GSM) equipment can be placed either in vertical
position on a wall or horizontally on a desk or in a shelf.
The SS-15 BRI (ISDN 2 GSM) and its antennas must be located as far as
possible from equipment that is sensitive to electromagnetic interferences
(radios, audio or video appliances, computer monitor, TV receivers etc). Also,
the GSM antennas must be mounted in a place with maximum strength of the
received signal.
For mounting the SS-15 BRI (ISDN 2 GSM) on a wall the mounting kit must be
used (plastic dowels, woodscrews, etc) provided by SS Telecoms.
Mark the position of a pair of holes
on the wall, spaced at 55 mm
apart.
Drill the holes in the wall.
Forcibly insert into the holes the
plastic dowels.
Thread the metallic woodscrews
into the plastic dowels leaving the
end to protrude outside for some 5
mm.
Hang the case of SS-15 BRI
(ISDN 2 GSM) in the two metallic
woodscrews and push it down a
little to get it fixed.
Figure 10. Mounting SS-15 on a wall
4.11
INSTALLING THE PROGRAMMING TOOL
The Programming Tool called ISDNCFG is required in order to configure and
control the SS-15 BRI (ISDN 2 GSM) equipment.
It also allows the sending and receiving of SMS messages from the computer
that is connected to the SS-15 BRI via serial cable.
This Operation, Administration, and Maintenance program runs under the
Windows Operating System.
To install the program, connect the SS-15 BRI to the PC that will be used for
programming, by means of the special serial cable for configuration.
