( 6 / 12)
DMX only operation
For the DMX operation, turn off the W-
DMX module by holding the MODE button
until both W-DMX and MODE buttons turn
RED.
Now connect the DMX cable to DMX-IN
connector and use WPSU as standard
DMX Scroller power supply.
DMX+ Wireless DMX operation
For W-DMX operation, turn ON the W-DMX
module by holding the MODE button until
the MODE button are lights GREEN. The
W-DMX function button will indicate the
W-DMX functionality as is shown in figure
at the bottom of this page.
W-DMX button has only one function; to
log OFF from linked transmitter. To log
off, hold for more than 5s.
There is an automatic backup of W-DMX line by the cable connection. If the W-
DMX is linked to transmitter and signal quality is bad, W-DMX active LED goes
OFF and the splitter will retransmit signal from IN/TRHU port. In normal state,
when W-DMX signal quality is good, the W-DMX active LED is ON.
W-DMX LED/ button signalization:
