( 3 / 8)
Connect power power input and output load to the DP5. Via fader you can select the
output value. This value is in LTP law with DMX input. For avoid changes via DMX please
setup DIP switch #10 to the position of disabling DMX.
LTP: Latest takes precedence: change of signal take controlling of output power.
Front panel description
1.
DMX in / DMX OUT connector
Pin 1
GND
Pin 2
Data -
Pin 3
Data +
Pin 4,5
Not connected
2.
DMX start address and MODE selector switch
a.
DMX address : 0-9 switches : active on TOP
b.
MODE switch : 10 switch :
i.
DMX & ANALOG – dip switch in position 1 – TOP
ii.
ANALOG only – DIP switch in position 0 – BOTTOM
In analog only mode the DMX OUT connector isn’t connected to DMX IN connector!!!
3.
ANALOG fader knob
i.
0-100% of output value
4.
POWER LED
i.
Solid GREEN – all OK
ii.
Blinking GREEN – over temperature
5.
DMX OK LED
i.
Solid GREEN – DMX signal OK
ii.
Off – DMX signal not presence
6.
DMX ERR LED
i.
Solid RED – DMX signal ERR – check cable for 2/3 inv. connection
ii.
Off – DMX signal not presence
Содержание DP6
Страница 7: ... 7 8 ...
