SRM X-Power, Руководство пользователя

Страница: 18 / 20

18
TROUBLESHOOTING / FAQ
My bike computer shows no power or cadence
Check if the X-Power pedals are fully charged, turned on and
paired with your bike computer. Follow the installation process
with the X-Power app and check the realtime data tab to
ensure the pedals show correct data.
I see three different sensors when pairing the pedals to
my bike computer
Your bike computer supports ANT+
™
and Bluetooth
®
and
therefore shows all sensors found. Make sure to pair only one
or the other. See
page 14
for more information on how to
pair to your device.
Power data is incorrect / Left - right balance is off
Follow the installation process on
page 10
with the X-Power
app once again. Make sure that you entered the correct crank
length and that you oriented the drive side crank downwards
when performing the angle calibration. If the problem persists,
please contact SRM - the info page of the X-Power app is
helpful for diagnosis.
I already have SPD cleats mounted on my shoes
The X-Power binding is compatible with all SPD compatible
cleats. However, a worn cleat might feel looser when engaged
than the enclosed new set. SRM recommends new cleats for
better engagement and power transmission. See
page 15
on how to adjust the binding and mount the cleats.
The body or binding is worn out. How can I replace them?
Remove the 4x Torx T10 screws on each side of the pedal
and remove the old binding. Mount a new set of bindings and
tighten the new screws with a torque of 4 Nm (3 lbf.ft) max.
Make sure to adjust the spring tension according to
page
15
. The complete pedal body can only be replaced at an
authorized SRM Service Center - please contact SRM for
more details.
How do I know I am on the most up to date firmware?
Use the X-Power app on your phone to connect to your
X-Power pedals. If new firmware is available, you will be
notified in the app.