Installation of the Vacuum Pump Interface on the
SRI 8610C GC
Crimp the two green/yellow wires
( from solid state relay and from
power jack ) to a single ring termi-
nal and then connect the ring ter-
minal to the chassis ground stud
with a lockwasher.
Connect the yellow wire from the
solid state relay to the A/D board
terminal labeled “D”. The A/D
board has eight digital outputs ( A-
H ). The yellow wire can be con-
nected to any of the digital outputs
if desired, but we normally use “D”
unless it is already occupied with
some other function.
Route the wires neatly through the
GC. Often there will already be a
wire bundle and clamp through
which you can run the wires.
December 2009
Page 7
SRI Tech Support 310-214-5092
www.srigc.com
