Installation of the Vacuum Pump Interface on the
SRI 8610C GC
Crimp the yellow and green/yellow
wires in the ring terminals. Con-
nect the yellow to terminal#3 and
the green/yellow to terminal#4.
Snap the plastic cover over the
solid state relay module.
Replace the aluminum plate letting
the four wires dangle for the time
being.
Use a hammer and screwdriver to
remove the knock out plate for the
power jack located on the rear of
the GC’s right side.
Use a file to smooth the
edges of the hole
so the jack slides in easily.
December 2009
Page 5
SRI Tech Support 310-214-5092
www.srigc.com
