12
D i s a s s e m b l y
1
Insert a 5 mm hex wrench into both end caps. Hold the drive
side wrench in place and turn the non-drive side end cap
counter-clockwise to remove it.
The drive side end cap is attached to the axle and cannot be
removed.
2
Remove the axle, by hand, from the hub shell.
3
Insert the 17 mm
Blind Hole Bearing Puller slotted attachment
through the non-drive side bearing. Align the attachment with
the bottom of the bearing, and tighten it inside the bearing.
Do not over tighten the slotted attachment.
For more detailed
assembly and usage, see your bearing puller's manufacturer's
instructions.
Thread the rod of the bearing puller into the attachment. Grip
the handle and forcefully pull out to remove the bearing from
the hub shell.
Remove the spacer from the hub shell; discard if replacing or
set it aside until the hub is ready for reassembly.
Remove the bearing from the bearing puller. Repeat this
process to remove the non-drive side bearing.
5 mm
17 mm
