38
Air Assembly Installation
2 0 0 / 6 0 0 H o u r S e r v i c e
A i r A s s e m b l y I n s t a l l a t i o n
Clamp the lower post into the Reverb Vise Blocks, with the seatpost
Clamp the lower post into the Reverb Vise Blocks, with the seatpost
head oriented downward.
head oriented downward.
Apply grease to the inside surface of the lower post approximately
Apply grease to the inside surface of the lower post approximately
30 mm down.
30 mm down.
Insert the air shaft/piston/seal head assembly into the lower post,
Insert the air shaft/piston/seal head assembly into the lower post,
threaded shaft end first. Use your fingers to guide and protect the air
threaded shaft end first. Use your fingers to guide and protect the air
shaft from getting scratched during installation.
shaft from getting scratched during installation.
NOTICE
Do not scratch the air shaft. Scratches will cause air to leak.
Press the seal head and air piston into the lower post.
Press the seal head and air piston into the lower post.
Push the air piston down into the lower post until the shaft end
Push the air piston down into the lower post until the shaft end
contacts the seatpost head inside the upper post.
contacts the seatpost head inside the upper post.
Push the upper post up to make contact if needed.
Push the upper post up to make contact if needed.
1
SRAM Butter Grease
2
3
