Model SR555
i
Series Stand-On Scale
Operating and Service Manual
Part No. MAN555
i
-KG_MICROBAN_201001
Page 6 of 22
S
Instruments, Inc.
,
600 Young Street, Tonawanda, NY 14150
Tel: 716-693-5977 Fax: 716-693-5854 URL:
www.srscales.com
email:
Copyright 2020
S
Instruments, Inc.
ASSEMBLY (Cont’d)
INSTALLING OPTIONAL HANDRAILS
STEP 1:
(Figure 4) Attach top of each of the Handrails (6) to the bottom right and left of the
Display Unit (1). Use two (2) screws and two (2) split-lock washers on each side; slightly tighten.
(Do not tighten all of the way.)
STEP 2:
Attach the bottom of the Handrails to the right and left side of the Base Assembly (2)
using one (1) screw and one (1) split-lock washer for each handrail. Tighten all six (6) screws
securely.
INSTALLING OPTIONAL HEIGHT BAR
STEP 1:
(Figure 4) Remove the set screw on the back
of the Display Unit (1) and in the Base Assembly (2).
STEP 2:
Slide the Height Bar (7) down through the
hole in the Display Unit and seat firmly into the Base
Assembly. Apply a small amount of Loctite
to the two
(2) set screws and reinstall, tightening securely.
INSTALLING OPTIONAL PRINTER
STEP 1:
(Figure 4) Slide the Printer Mounting Collar
(11) over the Mast (3). Position the Printer Mounting
Collar approximately 5 inches from the top of the mast.
Tighten the two (2) set screws to secure the Printer
Mounting Collar to the Mast.
NOTE:
The three (3)
holes on the Printer Mounting Collar should be towards
the top of the Mast (Figure 5).
Figure 4: Handrail/Height
Bar Diagram
Figure 5: Printer Mounting
Collar
Figure 6 Printer Mounting
Bracket
3
7
11
1
2
6
10
9
Continued next page
