Manual | Spectrum Mini 12x10W RGBAW 5in1
8. Operating Control Instruction
Master/Slave:
Master: The master should always work as a master as long as it is not set in a DMX mode whatever
other modes it is. And it send out the signal so that the slave synchronous with it. To avoid the host
signal and DMX512 signals interfere with each other, should cut off the DMX512 signals. The signal
lines are longer than 60 meters (32 lamps) ,should increase a signal amplifier.
Slave: the Slave must be set in DMX mode and the address code should be A001, to assure receive the
master’s signals correctly. Only one light can be set as a Master and others are slaves.
9. XLR cable connecting
XLR cable:
The standard way of connecting the XLR is: one end connects to the male plug, and the other end
connects to the female. As bellow: pin 1: ground, pin 2: negative signal, pin 3: positive signal
Noted: In order to avoid failures and interference signal transmission, we connect a
resistance120Ω
(1/4W)at the end of the DMX connecting as below:
