Manual | Color Designer 18x12W RGBAW+UV
Operation
Projector DMX starting address selection
The LED DISPLAY on the rear side of the base allows you to assign the DMX fixture address, which is
defined as the first channel from which the item will respond to the controller. If you set, for example,
the address to channel 7, the item will use the channel 7 to 15 for control.
All fixtures should be given a DMX starting address when using a DMX signal,so that the correct fix-
ture responds to the correct control signals. This digital starting address is the channel number from
which the fixture starts to listen to the digital control information sent out from the DMX controller.
The allocation of this starting address is achieved by setting the correct number on the display located
on the base of the device.
You can set the same starting address for all fixtures or a group of fixtures, or make different address
for each fixture individually.
If you set the same address, all the units will start to listen to the same control signal from the same
channel number. In other words, changing the settings of one channel will affect all the fixtures
simultaneously.
If you set a different address, each unit will start to listen to the channel number you have set,based
on the quantity of control channels of the unit. That means changing the settings of one channel will
affect only the selected fixture.
In the case of the fixture, which is 9 channels fixture when you select the standard channel mode,
you should set the starting address of the first unit to 1, the second unit to 17(16+1), the third unit to
33(16+17), and so on.
Control Board
The Control Board offers several features: you can simply set the starting address, switch on and off
the lamp, run the pre-programmed program or make a reset.
The main menu is accessed by pressing the Mode-button until the display starts flashing. Browse
through the menu by pressing the Up-button or Down-button. Press the Enter-button in order to
select the desired menu. You can change the selection by pressing the Up-button or Down-button.
Confirm every selection by pressing the Enter-button.You can leave every mode by pressing the
Mode-button.The functions provided are described in the following sections.
