Square SPG1, Начало работы

Страница: 5 / 7

ADHESIVE MOUNT
(OPTIONAL)
Secure Stand to your counter with the included adhesive mounting plate.
DRILL MOUNT
(OPTIONAL)
Secure Stand to your counter with a drill and the included drill mount.
NOTE
To remove the adhesive mount, pull the tabs on the mount slowly outwards. The adhesive will start to stretch until it detatches from the surface it was mounted on.
Plug the hub into Stand
Plug the cable into the bottom of
Stand.
Note:
If the cable exits the
base of Stand on the right side
(when the screen faces you), Stand
will swivel clockwise. If the cable
exits the base on the left side,
Stand will swivel counterclockwise.
Screw in the adhesive
mounting plate
Make sure the cable is firmly
pushed in, then screw in the
adhesive mounting plate.
Remove the
adhesive backing
Check that the plate is tightly
screwed in and the base of
Stand is locked, then remove
the adhesive backing.
Mount Stand to
your counter
Clean and dry the area where you
want to mount Stand, then firmly
adhere Stand into place. Press down
for 30 seconds and wait 30 minutes
for the adhesive to set.
Plug the hub into Stand
Plug the cable into the bottom of
Stand.
Note:
If the cable exits the
base of Stand on the right side
(when the screen faces you), Stand
will swivel clockwise. If the cable
exits the base on the left side,
Stand will swivel counterclockwise.
Drill the hole for the
drill mount
With a 3/16" drill bit, drill a hole into
your counter. Make sure your bit will
work on your counter material.
Line up Stand with the
drill hole
Line up the screw hole in the base of
Stand with the hole in your counter.
Double-check that the base of Stand
is locked with the cable exiting from
your preferred side.
Mount Stand
to your counter
Screw the drill mount into the base
of Stand through the bottom of your
counter. Turn the nut until it’s firmly
against the bottom of your counter.
Make sure the drill mount and
Stand are secure and Stand can
only swivel on a 180-degree axis.