23
Setup • Receiver
(BLACKBOX)
By default, the TINY-W
BF
camera is synchronized with its receiver on
channel 1
and the icon SYNC is green. (see SIGNAL mode in menu)
To change the synchronization channel or to add other sets (TINY-W
BF
camera/BLACKBOX receiver) in the same area, refer to the MANUALLY SYN-
CHRONIZING ONE OR MULTIPLE SETS IN THE SAME PERIMETER
section
(p.24).
INSTALLATION OF THE RECEIVER AND THE CAMERA
The strength of the wireless signal varies depending on the orientation of
the receiver. We strongly recommend installing the receiver on the same
side of the antenna of the camera (see figure below).
For best results, the antennas of the two devices must also point upwards
and their respective height should be approximately the same (see figure
below).
Sync
Channel 1
+
TREE
SIGNAL STRENGHT
SIGNAL
STRENGHT
INSTALLATION WITH THE SUPPLIED STRAP
WIRELESS SIGNAL TEST
The quality of the wireless signal between the TINY-W
BF
camera and the
BLACKBOX receiver can be checked on the camera. Perform the range test
after the final installation of the devices. To see the wireless signal icon on
the main menu, the WIRELESS option in Settings should be on.
1-Select the SIGNAL mode.
2-Select the Range test option.
Range Test
If the icon of the wireless signal is red, the signal is too weak. Move the
receiver or bring it closer. If the icon of the wireless signal is green and stays
green for at least 10 seconds, the signal is strong and stable enough to
enable wireless transmission of photos to the receiver.
Note:
If the receiver is turn off and not synchronized with the camera, the
signal icon remains red.
1. Insérez l’extrémité de la courroie dans la fente
qui se trouve au dos du mécanisme.
2. Insérez la courroie dans la fente sous le levier
et faites-la ressortir en arrière.
3. Créer une tension sur la courroie en la tirant vers
la droite, puis rabattez vers la gauche le levier pour
maintenir la position.
