Read Before Using
SPEED - ACCURACY - FREEDOM FROM STRIPES AND STREAKS
are yours - when you use this Spreader.
The spread width ranges from 4 ft. to 12 ft. wide, depending on the volume/density, particle size of
the material and the rate of travel.
The spread thins or feathers at the outer edges, eliminating sharp, “Edge of spread” lines which
cause stripes and streaks. Extra coverage can be given under trees and other heavy feeding areas
without showing “edge of spread” lines.
Gaps and double overlaps are less likely. Small errors in travel are forgiven and do not show.
WARNING: When spreading products containing herbicides, exercise extreme
caution with respect to careless spreading and to wind-drift.
CONTACT OF SOME PRODUCTS ON SOME PLANTS CAN BE FATAL.
If a dial setting is not found, use the size and weight comparison table found on page 16.
Determine a dial setting on the low side. If the setting proves to be too low, cover the area more
than one time. A higher setting can be used when a proven dial setting is established.
REMEMBER - Published dial settings can be approximate only. The operation of the spreader, the
condition of the material (damp or dry or over-pulverized) and weather conditions, are all contributing
factors.
For these reasons, it’s often a good idea to spread the area 2 times - at one-half rate - in cross
directions (SEE INFORMATION ON ONE-HALF RATE DIAL SETTINGS ON REFERENCE CHART ON PAGE
16. SPREADING AT ONE-HALF RATE DIAL SETTINGS IS HIGHLY RECOMMENDED UNDER DAMP &
HUMID CONDITIONS.
BECOME FAMILIAR WITH THE OPERATION OF THE SPREADER BEFORE
YOU PUT MATERIAL IN THE HOPPER.
Practice walking with the spreader, opening and closing the rate gate at the appropriate times.
Travel at a constant speed and operate the spreader lever position.
Remember: Open the rate gate after the spreader is in motion at operating speed (about 3 mph.,
or at a brisk walking pace).
Close the rate gate while spreader is still at operational speed.
Rotary Agitator
Use the rotary agitator only if needed. Free-flowing, lump-free materials will not require the agitator.
The rotary agitator is easily installed or removed. Note the clockwise rotation & sweep. Place felt
washer around spinner shaft before inserting agitator. - See page 9.
OIL BEARINGS AND ALL MOVING PARTS
Make certain the spreader is running freely!
Now You are Ready to Put Material in the Hopper
•
Make certain the rate gate is in closed position.
•
As insurance against spill damage and spill loss, put material in the hopper with the spreader on a
walk, driveway, paper, plastic, etc.
•
The spreader will be easier to use if you only half-fill the hopper. Later on you can fill the hopper if you
so choose.
•
Or for added capacity, the inverted bag in the hopper can serve as a capacity extension. Also, an
extension hopper, complete with filtering and pulverizing screen, is available from the manufacturer.
9
Border Patrol
72–Screen &
Extension Hopper
Assembly
84
75
57
Round Rain Cover 71
73
Exploded View
6
6
3
9
7
8
6
10
2
1
4
5
9
7
8
Rate Gate Assembly
65
64
