Parts List and Operating Instructions, Form No. 102663, Back sheet 2 of 4
Final Assembly (continued)
10. Turn the jack back up so that it is again resting on the column foot. Pump the jack to its maximum extension and
wedge the toe on the base. Loosen and remove the cylinder plug. Top off the cylinder again to the top of the
cylinder cap threads and open the release valve. Allow the oil level to drop approximately 1" and close the release
valve. Again, top off the cylinder with hydraulic fluid until flush with the top thread.
11. Reinstall the cylinder plug and tighten. Remove the wedge and allow the jack to fully retract. Close the valve
pump to full extension and build pressure. Check for leaks. Retract the jack. Check for leaks.
12. Install protective screw (35) and washer (34).
NOTE:
To extend service life, periodically lubricate pivot pins 250547 and 250076.
PARTS LIST
TOE LIFT JACK SIDE VIEW
