23
A.0100.301 – IM-FIP/08.00 EN (02/2014)
3) Assemble the pump body to the pedestal/
flange, taking care not to damage the
seal.
4) Lubricate the impeller with grease or
vaseline. For foodstuff applications use
appropriate food grease.
Push the impeller into the pump
body with a twisting movement in the
operating direction, centralizing the
impeller hub.
5) Assemble the front cover gasket and the front cover
(see section 2.9 Tightening torque for cap screws).
4.4 Disassembly of pedestal
See drawing sections 5.3 and 5.7.
1) Remove the pump with its components following the instructions in section 4.2.
2) Prize out the outer bearing seal (20).
3) Remove the retaining ring (19) from the pedestal.
4) Press on the impeller drive end of the shaft to remove the shaft (7) and bearing assembly.
5) Press off the ball bearings from the shaft and remove the retaining ring (17) and
spacer (18).
6) Press out the lip seal (14) if necessary to change.
7) Clean all parts that are going to be reused and check the shaft for wear.
4.5 Assembly of pedestal
See drawing sections 5.3 and 5.7.
1) Mount ball bearings, spacer and retaining ring on the shaft (see pos 16, 17 and 18).
2) Mount lip seal (14). Lubrication with soap solution will ease the assembly.
3) Press in the shaft including the bearing assembly into the pedestal.
4) Mount the retaining ring (19) and the new lip seal (20). Lubrication with soap solution (for
foodstuff applications use appropriate food grease) will ease the assembly.
5) Assemble the pump according to the instructions in section 4.3.
4.6 Waste handling/material recycling
At the products end of life, please dispose of the product according to applicable law.
Where applicable, please disassemble the product and recycle the parts material.
