SPT WA-1288E, Инструкция по эксплуатации

Страница: 12 / 21

Water drainage
Location of the remote controller
-During dehumidifying modes, remove the drain plug from the back of
Use the remote controller within a distance of 8m (26 ft) from the
appliance, pointing it towards the receiver.
When setting the timer, the remote will automatically transmit
signal to the unit at the specified time.
Note: if remote is kept in a position that hinders proper signal
transmission, a time lag of up to 15 minutes may occur.
the unit, install the drain connector(5/8" universal female mender) with
3/4" hose(locally purchased). For the models without drain connector,
just attach the drain hose to the hole. Place the open end of the hose
directly over the drain area in your basement floor.
NOTE:When the continuous drain hose is not used, ensure that the drain
plug and knob are installed firmly to prevent leakage.
Remove the
drain plug
Continuous
drain hose
-When the water level of the bottom tray
reaches a predetermined level, the unit
beeps 8 times, the digital display area
shows "P1" . At this time the air
conditioning/dehumidification process will
immediately stop. However, the fan motor
will continue to operate(this is normal).
Carefully move the unit to a drain location,
remove the bottom drain plug and let the
water drain away. Reinstall the bottom
drain plug and restart the machine until
the "P1" symbol disappears. If the error
repeats, call for service.
NOTE: Be sure to reinstall the bottom
drain plug firmly to prevent leakage
before using the unit.
Bottom drain
plug
Operation
Handling the remote controller
11
Fig.20
Fig.21
CAUTIONS
- The air conditioner will not respond if curtains, doors or other barriers block
the signal from the remote controller to the unit.
- Prevent any liquid from coming in contact with the remote controller.
- Do not expose the remote controller to direct sunlight or heat.
- If the infrared signal receiver on the unit is exposed to direct sunlight, the air
conditioner may not respond. Close curtains/blinds to block sunlight from
falling on the receiver.
- If other electrical appliances react to the remote controller, move those
appliances if possible.
Installing / Replacing Batteries.
The remote controller is powered by two AAA
batteries. The batteries are housed in the back
of the remote, protected by a cover.
1. Remove the cover by pressing down and sliding
off (according to arrow direction).
2. Remove old batteries and insert new batteries,
placing the (+) and (-) ends correctly.
3. Replace cover by sliding it back into position.
After replacing batteries, set the clock on the remote
controller (refer to page 14).