SPT SD-2225DS, Инструкция по эксплуатации

Страница: 19 / 21

Error Indications
17
ISSUE POSSIBLE CAUSE WHAT TO DO
Dishes are not
cleaned
Dishes were not properly loaded Reload dishes properly.
Selected wash cycle was not
powerful enough
Select a more intensive wash cycle.
Not enough detergent Use more or change brand of detergent.
Items are blocking the path of the
spray arm Rearrange items so the spray arm can
fully rotate.
The lters are dirty/clogged or
installed incorrectly Clean the lter and/or check installation.
Cloudiness on
glassware
Combination of too much detergent
with soft water Use less detergent and/or select the
shortest wash cycle to clean glassware.
The lters may be dirty or clogged Clean lters and/or check installation.
Black or gray marks
on dishes Utensils may have rubbed against
dishes Use a mild abrasive cleaner to eliminate
marks. Load more carefully.
Detergent left in
dispenser cup
Dishes blocked the detergent cup Re-load dishes properly.
Dishes are not dry
Improper loading Re-load dishes properly.
Not enough rinse-aid Rell the rinse aid.
Dishes were removed too soon
Do not remove dishes from the
dishwasher immediately after wash.
Wrong cycle selected
Short cycles have lower cleaning
performance. Choose a more intensive
cycle.
Dishes/cutlery have low-quality
coating Water drainage is more difcult with
these items. Dishes/cutlery of this type
are not suitable in this dishwasher.
INDICATION MEANINGS POSSIBLE CAUSES
E1 Restricted water inlet Water supply is not turned on or
restricted; or water pressure too low
E4 Overow Some element of dishwasher leaks.
WARNING!
If overow occurs, turn off the main water supply before calling for service.
If there is water in the base pan due to an overll or small leak, the water should be removed
before restarting the dishwasher.