SPRT SP-RMD17, Руководство пользователя

Страница: 15 / 17

13
the printer and the ERROR indicator flashes twice, then indicator off. The printer enters into the
normal working mode.
2.7 Self test
The self-test will check the condition of printer, if the printer prints out the self-test receipt
correctly, it means the printer works normally except interface with host. Otherwise it needs to
repair.
Self test method: Under power off status, paper house closed and ensure there is paper
inside, keep pressing FEED button and power on the printer, red indicator will flicker every 1s,
then release FEED button after indicator flickers 3 times, printer will print out self-test paper. Self
test paper can test the printer working normally or not, if the printer can print out self test normally,
it means the printer is normal except interface with host, otherwise it need to be repair.
2.8 Hexadecimal Printing
Turn on the printer according to the step below, it will enter the mode of Hexadecimal Printing.
Power off, Press
【
FEED
】
button with opening the paper house cover. Power on, close the paper
house cover. The printer will print out 3 lines as below:
Hexadecimal Dump
To terminate hexadecimal dump,
Press FEED button three times.
This means the printer has entered hexadecimal printing mode, and under this mode,all of the
input will be printed out as hexadecimal number. Paper will feed one line with single-click of
“FEED” button, after 3 times, it will print out “*** Completed ***”, and exit hexadecimal printing
mode.
2.9 Printer Parameter Setting
This function is for the setup of parameters.
Steps for setting parameters:
Power off, press
【
SET
】
button and power on, the printer will enter into setting mode,and print the
firs t parameter option and current setup. Details could be checked on attached Appendix A.
Steps for exiting of parameter setup:
Press
【
SET
】
button and
【
FEED
】
button at the same time to save the setup of parameter and
exit, the printer will enter into normal mode.If power off directly, parameters will not be saved.
2.10 Entering program upgrading mode
When printer powers off, press
【
FEED
】
and
【
SET
】
buttons, power on and release the
buttons. Printer will enter into upgrading mode, status indicator light will flicker every one second.