4
Chapter 3
Operation Method
3.1
Using Preparation
3.1.1
Battery Installation
1. Put the battery into the battery slot from the side with pins and press the
other side into case.
2. Then tighten the M2.5*4 countersink screw (as below Pic.)
3.1.2 Paper Roll Installation
1. Press the OPEN button to open the paper case cover (as shown in Figure 1),
put your finger in the finger groove in the baffle, slide the paper roll baffle
outward till it is suitable for the width of the paper roll (as shown in Figure 2) .
2. Load the roll paper with the downward thermal face, pull out a part of paper
and put them in the middle of the paper out orifice. (The end of paper is
beyond the tear cutter.)
(see Figure 3).
3. Shut down paper case cover and cut off the redundant paper
