5
How to Add IPA
6
Build Platform Information
MAX
MIN
500 mL
1
2
Minimum
500 mL
Required per tank
Maximum
2 Liters
Required per tank
Isopr
opyl
Alcohol 91%
Recommended
Always wear gloves and
proper eye protection.
Build Platform Adaptor
Compatible with Pro 55 and Pro 55s
Open the tank lid and add at least 500mL of IPA 91% or greater
to each tank. IPA 99% and ethanol may also be used depending
on preference, availability, and material requirements.
If the volume of IPA is insufficient to run a cleaning cycle, the
onboard computer will detect this and notify you.
Keep the tank lid closed to prevent the evaporation and
contamination of IPA.
When new IPA is added, hydrometers may float
for a few minutes before sinking
Depending on which SprintRay 3D printer you have, you may
need to attach a magnet and/or use a fitment adaptor when
using ProWash S.
How to Install the Magnet
If using Pro95 or Pro55, you’ll need to install the provided
magnet to enable the platform wash. Thoroughly clean the side
of the build platform before attaching the magnet sticker.
Using the Build Platform Adaptor
If using a Pro55 or Pro55 S, you’ll need to use the
included adaptor to enable the platform wash. Place the
adaptor atop the wash chamber so that the opening is
on the right and run a cleaning cycle as normal.
1/4 inch
1/2 inch
Center
Magnet
Pro55
Print Platform
Place magnet on the right side
Pro95
Print Platform
Place magnet on the right side
Label
Center
Magnet
Right Side
Right Side
Printer Model
Pro95
Pro55
Pro95 S
Pro55 S
Install Magnet
Yes
Yes
No, It is embedded
No, It is embedded
Use Adaptor
No
Yes
No
Yes
