Sprinte ASP 116 evolution, Руководство по установке и обслуживанию

Страница: 29 / 56

ASP 116 EVOLUTION
– INSTALLATION MANUAL
All rights reserved, including translations.
29
7 STOP PRECISION SETTINGS
Only with absolute readers K04SP/K05SP
Shaft’s learning procedure shall have been done (§6.4)
Adjustment of the floor’s heights with moving down

Move the car to the highest floor.

Move down and stop on every floor.

On each floor, measure the stop inaccuracies.

Change the floors heights in the menu « FLOORS POSITION » (see below) and Reset the controller

Do all the procedure once again, to check your corrections.
+
…
+
…
Adjust the floors heights:
…
Stop precision while moving up:

Move the car to the lowest floor.

Move up and stop on every floor.

On each floor, measure the stop inaccuracies.

Adjust the DEALA parameter if there is a precision difference with a down travel (see below).

+
…
…
Add your measured value if the car stops below the floor (+ xx mm) or remove your measured value if the car
stops above the (- xx mm).
CONFIGURATION
READER
LEVEL xx
XXXX m
Choose
CONFIGURATION
READER
FLOORS POSITION
CONFIGURATION
READER
SHIFT UP STOP
XX mm
ENTER
ENTER
ENTER
ENTER

-

-

-

-

-

-

-

-

-

-