V11 Hot Water
Connect the probe and heater control in accordance with this diagram.
Additional Wiring
DISCLAIMER
THE MANUFACTURER RESERVES THE RIGHT TO MAKE CHANGES TO ANY PRODUCT HEREIN TO IMPROVE
RELIABILITY, FUNCTION OR DESIGN. THE MANUFACTURER DOES NOT ASSUME ANY LIABILITY ARISING
OUT OF THE APPLICATION OR USE OF ANY PRODUCT OR CIRCUIT DESCRIBED HEREIN.
For more information and videos on how to use Spring controllers please visit: www.springltd.co/videos
To heater (+12V start
signal 150mA max).
John Guest 1/2” or 12mm Equal Tee fitting not supplied. Available on
request. Specify 1/2” or 12mm probe at time of order.
When the unit is off if the temperature of the water falls to the
frost
temperature (FtP) and the frost protection is enabled, the pump
and heater are turned on.
The controller constantly monitors the Dead End detection and Low
Battery protection* while in frost mode to protect your system.
Temperature
probe.
* Your battery is at risk of permanent damage if you disable low battery cutoff and continue
to use your controller for long periods when the battery voltage has fallen below +10.5V.
