Spraying Systems AUTOJET 1750+, Руководство пользователя

Страница: 7 / 45

7
3.3 PLUG AND SPRAY CONNECTIONS
All the connections are the same as the full system. Located on the bottom of the panel the connections are as follows.
•
Power input connection, route power cord through oval opening on right - hand side of frame and plug in 120 VAC
outlet rated for at least 5A.
•
4 - 20 mA - Remote Duty Cycle Input. Analog input is accessible through this connection.
•
Main - Nozzle Liquid ON/OFF connection. Use this output for the connection on all electric spray nozzles and
cylinder air.
•
Trig - Is the input connection for the system trigger or sensor. Connect cable to Trig connection that will be used to
start spray sequence. Available triggers are as follows, the one used should be based on the customer ’ s application.
- Trigger cable (for use with customer - supplied trigger signal)
- Sensors including: object, proximity, laser (short/long), thru - beam, and full spectrum color sensor.
- Hand - held trigger unit
- Foot switch
•
Aux - Nozzle air ON/OFF for fan and atomizing air control.
•
T. int . - Used for the optional trigger interlock or level switch input. Trigger Interlock controls the state of run/
standby mode.
PLUG AND SPRAY COMPATIBILITY
The 1750+ can be mounted to the universal frame with mobile cart. Plug and Spray provides quick hook up for all
nozzles, an Air Control Package (ACP), triggers, and any other compatible SCS Series accessories including a level
switch, an interlock cable, and the remote setpoint cable. Plug into GFCI outlets.
POSITION OR MOUNT THE SYSTEM
Find a convenient location for the 1750+ AutoJet
®
Spray Control System within a reasonable distance of your spray
application and easily accessible to a properly grounded power outlet. The unit must be installed when the cord is
connected, the plug can be easily reached and easy to remove from the outlet.
- Determine if the unit will be free - standing or wall mounted.
CONTROL PANEL ONLY VERSION
If you have the Control Panel Only version the unit should be wall mounted.
Install wall anchors that are designed to support at least 25 lbs., according to the anchor manufacturers ’ specifications.
The mounting holes are on 5 7/16” (138 mm) centers and are made for 1/4” (6 mm) screws with 3/8” (10 mm)
diameter screw heads. Secure the Model 1750+ to its selected location.