Spraying Systems Co 23624-30L, Руководство пользователя

Страница: 8 / 12

8
5. Insert stem assembly (5) through inlet and metering bodies
(6 & 16).
6. Install gasket (18) on packing screw (19).
7. If packing cup (17) was not previously removed from packing screw
(19) apply a drop of light oil on packing cup and carefully thread
packing screw over threads of stem sub-assembly (5).
8. If packing cup (17) was previously removed from packing screw (19),
apply a thin coat of light oil on packing cup and insert into packing
screw with ·flat side facing hex on packing screw. Note, packing cup
must be installed in correct direction. Carefully screw packing screw
with packing cup over threads of stem sub-assembly (5).
9. Thread flat side of hex stem nut (20) onto threaded end of stem
subassembly (5) until approximately 3/16" of threaded
stem projects from recessed surface of stem nut (20).
10. Assemble trigger (25), trigger guide (26), and roll pins (23 and 24) if
previously disassembled. Roll pin (23) slot should face toward
threaded end of trigger guide (26). Lubricate area where roll
pin (23) contacts trigger guide (26) with grease.
11. Install #6 burr (22), spring (21), and end of stem sub-assembly (5)
which has hex stem nut (20) onto trigger guide. Do not allow hex stem
nut (20) to drift from position on stem sub-assembly (5).
12. Tighten hex stem nut (20) to trigger guide (26) using a backup wrench
on the fiats of trigger guide (26).
13. Tighten packing screw (19) securely by wrenching on the hex of the
inlet body (16) and the hex of packing screw (19).
14. Place body-trigger assembly (5 through 26) in left housing (2) making
sure roll pin (24) is engaged in hole in left housing.
15. Install lock spring ring (33) in left housing (2).
16. Place trigger lock' (32) in left housing (2).
17. Install spring sub-assembly (27 through 31) in left housing (2) behind
trigger guide (26).
18. Install right hand housing (2) and seven screws (1). Be careful not to
over tighten screws.
19. Install valve seat (4) and cap (3) and tighten securely.
20. Lock trigger before attaching to pump.