Spraying Systems Co 23624-30L, Руководство пользователя

Страница: 3 / 12

3
WARNINGS & PRECAUTIONS
IMPORTANT: READ ALL INSTRUCTIONS BEFORE USING SPRAY GUN
IT IS IMPORTANT TO RECOGNIZE THE PROPER SAFETY PRECAUTIONS WHEN
USING A SPRAY GUN. WHILE THE METERJET® IS A RELATIVELY LOW-PRESSURE
SPRAY GUN, DO NOT AIM, IT AT ANY PERSON OR PART OF THE BODY. FLUIDS
UNDER PRESSURE CAN PENETRATE HUMAN SKIN AND CAUSE SEVERE INJURY.
CHEMICALS CAN ALSO CAUSE SEVERE BURNS OR INJURY.
CAREFULLY INSPECT THE METERJET SPRAY GUN TO MAKE SURE THREADED
CONNECTIONS ARE SECURE AND NOT LEAKING. ALSO INSPECT THE TRIGGER
LOCK TO MAKE SURE IT HOLDS THE TRIGGER FORWARD WHEN ENGAGED
(REFER TO TRIGGER ADJUSTMENT PROCEDURE FOR MORE INFORMATION).
THOROUGHLY CLEAN THE METERJET SPRAY GUN AFTER EACH USE.
SPRAYING SYSTEMS CO. STRONGLY RECOMMENDS THE USE OF APPROPRIATE
SAFETY EQUIPMENT WHEN WORKING WITH POTENTIALLY HAZARDOUS
CHEMICALS. THIS EQUIPMENT INCLUDES, BUT IS NOT LIMITED TO, A
PROTECTIVE HAT, SAFETY GLASSES OR FACE SHIELD, CHEMICAL RESISTANT
GLOVES, LONG-SLEEVED SHIRT, LONG PANTS, AND A CHEMICAL RESISTANT
APRON. REMEMBER TO READ THE CHEMICAL MANUFACTURER'S LABEL AND
FOLLOW ALL DIRECTIONS.
HEED ALL THESE WARNINGS or serious and permanent injury may result.
1. DO NOT aim gun at any person or any part of the body. Fluids under
high pressure can penetrate the human skin and can cause severe
injury, possibly resulting in amputation or death. Hot liquids and
chemicals can also cause burns or injury. If any part of the body comes
in contact with the spray stream, immediately consult a physician.
2. DO NOT at any time place hand or any other part of the body in front
of a spray nozzle or tip.
3. DO NOT alter equipment in any manner; if repairs are necessary, use
only genuine factory repair parts supplied by Spraying Systems Co.
4. DO NOT exceed maximum operating pressure of the lowest rated
accessory item within the spray system, even though some of the
accessories have a higher maximum pressure rating.
5. DO NOT leave equipment under pressure unattended at any time. If a
pump is used, relieve line pressure by shutting off power to pump,
turning off the liquid supply to the pump, and actuating the trigger
until all fluid ceases to flow. If gun assembly is equipped with trigger
lock ring; then position trigger lock to the “locked” position.