FresneLED 200 UD - PCLED 200 UD
7
FUNCTIONING MODE
• The fixture automatically detects the functioning tension in a range between 100÷240V.
• The luminaire can be connected to a dimmer and, at the same time, it can be set through the local potentiometer or
through a DMX console
• Control priority: the fixture works according to LTP mode (Latest Takes Precedence)
CHANNELS: 1 - Master Dimmer (Coarse)
2 - Master Dimmer (Fine)
3 - Strobo Effect
1) LOCAL POTENTIOMETER Mode: This is the factory configuration. In this mode it is possible to adjust the luminaire
light intensity from 0 to 255 using the buttons UP (+) and DOWN (-) ⑧
⑧
.
2) DMX Mode: To control this mode it is necessary the connection through DMX cable from a control device (ex.
console) to the luminaire DMX IN connector. It is possible to assign any DMX address from 001 and 512, by using the
buttons UP (+) and DOWN (-) and then confirming the choice with the button ENTER/MODE. More luminaires can be
chain connected, connecting the DMX THRU of a luminaire to the DMX IN of the following fixture.
SET-UP MENU (see Fig. 2)
When the display is off, push any button to activate the visualisation.
Push the MENU button to access the luminaire set-up.
With the buttons UP (+) or DOWN (-) it is possible to change the set-up values. Press ENTER/MODE to confirm and pass
to the following option.
• DIMM: curve selection and set up effect
• DISP: activate / deactivate Display
• FRE: PWM frequence set up
• FAN: fan silence / speed set up
• CAL: Min / Max value limits set up of light intensity
• DFSE: reset to manufacturer set up
• REM: Not implemented
DISP
DIMM
(dimmer setting)
EFF
(effect)
CUR
(curve)
HALO
(halogen lamp
)
emulation with DMX
HENO
(discharge lamp
emulation with DMX)
QUAD
(quadratic curve)
LIN
(linear curve)
ON
(display
always on)
OFF
(display
always off)
FRE
320 – 1200 Hz
FAN
ON
SILE
(silent mode)
CAL
(calibration DMX signal)
MIN
(set the min value
of brightness)
DFSE
(load default)
REM
(set remote ID)
0 – 250
MAX
(set the max value
of brightness)
SURE
CHANNEL 3 (Effect Channel) - DMX TABLE
DMX - effect
DMX - range
Dimmer
0 - 9
Sync Strobo Effect (from 0,5 to 30Hz)
10 - 57
Dimmer
58 - 59
Pulse Effect from ON to OFF (slow to fast)
60 - 108
Dimmer
109 - 110
Pulse Effect from OFF to ON (fast to slow)
111 - 159
Dimmer
160 - 161
Random Strobo (slow to fast)
162 - 207
Dimmer
208 - 209
Random Strobo (slow to fast)
210 - 255
