LE-4100-6-A
Remote Control LED Spotlight
12-24V DC, 5000 Lumens - (1) Wireless Remote - 6" Stanchion Mount
Instruction Manual
Thank you for your purchase of the Larson Electronics LE-4100-6-A remote control LED spotlight.
IMPORTANT
READ CAREFULLY BEFORE INSTALLING THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE. THE
LE-4100-6-A
MUST BE WIRED IN ACCORDANCE WITH NATIONAL ELECTRICAL CODE AND
ALL APPLICABLE LOCAL CODES. PROPER GROUNDING IS REQUIRED FOR SAFETY.
WE STRONGLY ENCOURAGE ONLY A LICENSED ELECTRICIAN INSTALL, OPERATE AND MAINTAIN THIS
PRODUCT. IF YOU ARE NOT QUALIFIED OR UNFAMILIAR WITH ANY ASPECT OF THIS INSTRUCTION SHEET,
CONSULT AN ELECTRICIAN. THERE ARE NO SERVICEABLE PARTS INSIDE.
WARNING:
MAKE SURE POWER IS TURNED
OFF
BEFORE STARTING THE
INSTALLATION OR PERFORMING ANY MAINTENANCE.
RISK OF FIRE/ELECTRIC SHOCK –
DISCONNECT POWER AT BREAKER BEFORE INSTALLING OR SERVICING.
RISK OF PERSONAL INJURY –
FIXTURE MAY BECOME UNSTABLE OR DAMAGED IF NOT INSTALLED PROPERLY.
RISK OF BURN –
ALLOW FIXTURE TO COOL BEFORE SERVICING.
Larson Electronics, LLC
Phone: (877) 348-9680
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
3
MOUNTING
The light is mounted on a 6" stanchion post compatible with 2-pin Perko sockets. A
stanchion mount enables the light to be easily installed and removed for storage.
For installation to existing Perko socket,
carefully engage stanchion into base
socket. As it slides into socket, make sure the alignment screw at rear of stanchion
slides into notch at rear of socket. Push stanchion down until it engages with
electrical connector at bottom of socket. Lock unit in place by sliding lock collar
into the top of the socket and rotate clockwise. Check to make sure stanchion is
secure in the socket.
For installing Perko socket, follow steps
page 2
.
The LE-4100-6-A from Larson Electronics is a LED Search Light w/ Stanchion
Mount that provides intense output in outdoor locations and is recommended for
lighting support during nighttime operations, emergencies, patrolling, and more.
This LED light operates on 12 V or 24 V DC and provides 5000 Lumens of output
during use. Equipped with a wireless remotes, the LED light with white housing is
compatible with stanchion mounting installations and features a white anchor light.
WARNING: CHECK PRODUCT LABEL FOR CORRECT VOLTAGE!
Verify supply voltage matches product voltage rating as labeled.
SAFETY NOTICE:
◎
If replacing LED module, the LED module connector should be
connected correctly for positive and
negative wires.
RED and BLUE: Positive (+)
BLACK and BROWN: Negative (-)
◎
FCC RULE Part. 15.21
：
Changes or modifications not expressly
approved by the party responsible for compliance
could void the user’s
authority to operate the equipment.
◎
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device
may not cause harmful
interference, and (2) this device must accept any interference received,
including interference
that may cause undesired operation.
◎
This searchlight is a Radio Frequency (RF) device which operates on
Channel 433.92 MHz. It will send out RF energy
when it is in operation.
1.
RF energy may affect some electronic equipment.
2.
Some electronic equipment on vehicles or boats may be affected by
RF energy.
