FresneLED 200 DMX - PCLED 200 DMX
7
• CURVE:
Choice among 3 curves that correlate the control
signal variation and the luminaire brightness:
1) Incandescent: extremely smooth with minimal light
intensity variations between consecutive steps.
Comparable to halogen lamps under dimmer.
2) Standard: smooth adjustment but faster than the
previous one.
3) Fast: almost linear adjustment.
• FREQ PWM:
It is possible to change the PWM frequency from 244
to 1200Hz to avoid interferences in the video cameras.
• FAN SPEED:
It is possible to adjust the speed/noise from 1 to 5.
1) SLOW
5) FAST
The unit is equipped with a temperature automatic
control system, so also in case of high ambience
temperature and “fan” on “slow” it automatically
adjusts the LED power to keep it in the safety limits.
• BACK LIGHT:
It activates or deactivates the display backlight:
- ON the display is always illuminated
- OFF the display switches off after about 30 sec.
FUNCTIONING MODE SET-UP
The luminaire is foreseen to be used in several
functioning modes:
• LOCAL
• DMX
When the display is off, push any button to activate
the visualisation.
The mode set-up is done by touching the buttons of
the display (Fig. 2) in the following way:
1 – Push the button ENTER/MODE
2 – Push the button UP (+) or DOWN (-) to select the
desired mode.
3 – Push the button ENTER/MODE to confirm
1) LOCAL Mode
This is the factory configuration. In this mode it is
possible to adjust the luminaire light intensity from 0
to 255 using the buttons UP (+) and DOWN (-) ⑧
⑧
.
2) DMX Mode
To control this mode it is necessary the connection
through DMX cable from a control device (ex. console)
to the luminaire DMX IN connector.
It is possible to assign any DMX address from 001 and
512, by using the buttons UP (+) and DOWN (-) and
then confirming the choice with the button ENTER/
MODE.
More luminaires can be chain connected, connecting
the DMX THRU of a luminaire to the DMX IN of the
following fixture.
SET-UP MENU (see Fig. 2)
Push the MENU button to access the luminaire set-up.
The editable options are:
• CURVE
• FREQ PWM
• FAN SPEED
• BACK LIGHT
With the buttons UP (+) or DOWN (-) it is possible
to change the set-up values. Press ENTER/MODE to
confirm and pass to the following option.
