combi 150W CDM Fresnel
combi 150W CDM Fresnel
FOCUS AND REGULATION
The luminaire should be at the minimum distance
from the object it is illuminating, as indicated on the
label.
Using the side handle
⑥
it is possible to loosen the
projectors when they are locked in a certain position
and thus change their inclination.
In the same way, the projectors can be rotated with
respect to their vertical axis by rotating on their
hooking hinge.
By turning knob
⑧
the lamp carriage is shifted
forward or backward to widen or narrow the beam of
light respectively.
CLEANING
For utmost projector performance, both the lens and
the reflector must be periodically cleaned.
Always remember to9 disconnect the projector from
the mains and let the lamp cool before proceeding to
any cleaning or servicing operations.
MAINTENANCE
The projectors must be serviced at least once a year to
check the integrity of their electrical and mechanical
parts. For this purpose, you should conctact only a
qualified dealer, to ensure proper service.
CHANGING THE LAMP
Open the projector lamp tray by means of knob
②.
Insert the appropriate bulb bearing in mind that it can
be damaged by contact with the skin or other grasy
materials. Close the upper cover pushing the knob.
• On cold start, the lamp will take a few minutes to
reach full brightness.
• Once switched off, wait approximately 10 minutes
before turning on again.
• Check the effective life-span of each bulb. Indeed,
it is necessary to replace the bulb (even if it still
works) when it has reached its maximum life time
as recommended by the manufacturer.
Using of the lamp beyond its recommended life time
considerably increases the risk of explosion.
• Use only lamps listed in the table on Appendix A.
WARNING:
•
For safety reasons always disconnect
the projector from the mains before
opening them to change the lamp
•
Start off of high voltage lamp: never
insert or remove the lamp when fixture
is powered on
•
Never turn on the lamp if the lens is
damaged to avoid UV trasmission and
the risk of explosion
•
Let the lamp cool down completely befo-
re opening the projector
6
