11
3.2.3 Automatic Tilt System
To enable the tilt alarm - simply press the tilt alarm button on the control panel and then wait approximately 15
seconds. During these 15 seconds the tilt alarm indicator light will continue to flash. When the indicator light
becomes constant the tilt alarm has been set.
3.2.4 Directional scanning
(1) Press the Speed key until it is at 0 r.p.m, the laser module will stop spinning. Press the Key Directional
scanning; the laser module will scan directionally. If press the key repeatedly, the angle of scanning of laser
module will continuously change as follows: 0
°
-10-
°
45
º
-90-
°
180
°
-0
°
.
(2) Press the Key Left-spinning or the Key Right-spinning to change the direction of scanning.
